| |
All
MAG-HYTEC products are covered by a lifetime limited warranty
to the original owner against defects in parts and workmanship.
O-rings are covered for five years. |
|
|
.
| |
|
|
|
As
the metallic components in transmissions and axles wear, they generate
very fine particle debris that becomes suspended in the lubricating
oil. A suspended magnet acts as a filter to contain these particles,
keeping the fluid cleaner and extending component life. Periodic checking
and cleaning of the magnet is recommended for maximum fluid service life.
|
|
|
|
|
|
|
| |
• |
Average of double the
fluid capacity |
| • |
Ease of Service |
| • |
The dipstick is knurled
for quick removal, the flat is marked low/high to check lube level and
a magnet, which acts as an open filter is in the lower end. The
MS 7/8 - 14 THD port is large enough to use for filling. |
| • |
The magnet-filled drain
plug is the same MS port as the dipstick. Both the dipstick and
drain are O-ring sealed. |
| • |
The sending unit fitting
is 1/8 pipe THD and shipped with a stainless pipe plug. |
| • |
The calibration plug is
centered on the serial number plate and approximates the stock cover
fill plug for factory fluid level. |
| • |
The O-ring is snapped
into the inverted "V" groove for a positive seal without
gasket or silicone. |
| • |
Plugs, cap screws and
washers are stainless steel in most applications. |
| • |
Mag-Hytec manufactures
the best covers and pans available today.
|
|
|
